Horizontal carbonization furnace

     A horizontal carbonization furnace is an externally heated charcoal burning furnace. When making a carbonization furnace, there are three layers of high-temperature insulation cotton inside. There is a smoke purification system installed behind the furnace, which is smokeless and environmentally friendly. Meet current environmental requirements. During carbonization, a fuel rod needs to be used to ignite the wood at the bottom of the furnace, and external heating is used to evenly heat the wood inside the furnace, decomposing wood tar, combustible gases, and so on. Then, through the flue gas purification system for recycling, the combustible gas is returned to the bottom for full combustion, which can reduce the addition of fuel rods.

Horizontal carbonization furnace operation theory;

1; When burning raw charcoal in a horizontal carbonization furnace, the wood should be placed in order inside the furnace. Smaller wood cannot be placed at the bottom of the furnace because the furnace bottom has a long heating time and is prone to breakage.

2; After the ignition starts, as the temperature rises, the moisture in the wood will be expelled as the temperature rises. At this time, the fuel rod cannot be arbitrarily reduced, but it needs to be continued to be added. At this point, you should always pay attention to the temperature gauge and remember to open a valve behind the furnace at all times. The purpose is to allow the wood tar inside to flow down to avoid clogging the pipeline.

3; When the temperature reaches a certain level, combustible gases are generated. At this point, the firing of salary sticks cannot be stopped. Just reducing the increase in salary sticks.

4; When the combustible gas is burned out, it proves that the carbonization furnace has completed carbonization. At this point, it is necessary to be patient and wait until the temperature drops, and not open the furnace door at once, as this can easily cause an open fire. But wait until the temperature drops to around 50 degrees Celsius before you can open the furnace door to collect charcoal without getting too hot.

Alright, that's all for the structure and operating instructions of the horizontal carbonization furnace. If you have any questions or doubts, please discuss them together!